Troubleshoot Craftsman Garage Door Opener Flashing Light

Brass contacts in garage door opener light bulb socket there are two brass contacts in the light bulb socketof a garage door opener.

Troubleshoot craftsman garage door opener flashing light.

One contact runs down the side of the socket and the other is at the bottom. An open door will not close if the infrared beam is broken. It s important to get this switch at just the right distance from the motor so that the door is able to close all the way but the motor also knows to stop running. If the garage door has been repeatedly used this may have tripped the overload protector in the motor.

If this doesn t fix your problem then the problem is more than likely the safety reversing sensors. Try making small adjustments. Liftmaster motors will not operate when something obstructs the infrared beam between the safety sensors at the bottom of the garage door tracks. Troubleshooting a liftmaster opener with a flashing light involves inspection of the safety reverse sensing system.

Over time these brass contacts will flatten causing the connection with the light bulb to be intermittent. Loosen the wing nut holding up the photo eye and adjust them until both sensors are properly aligned. The chamberlain liftmaster craftsman garage door opener wall buttons will flash when the opener is placed in lock out mode. Wait for 15 minutes for the overload protector to reset before operating the garage door opener again.

This is related to the up limit switch. If the sending sensor with the amber led is not lit check the wire and connections for that sensor. T his is a pretty uncommon problem but one that can happen after you ve first installed your garage door opener. To fix this issue first locate the two photo eyes attached to your garage door and clean the lens using a soft microfiber cloth.

Press and hold the up button till the garage door is in the fully opened position press the adjustment button to confirm. Sensors are completely misaligned or sensor wires are broken. Safety sensors are not installed connected or wires may be cut. To unlock your garage door opener push the lock button for 5 seconds.

Once you see the double flash press the control button on the remote control. Button or wall panel push button is flashing. Craftsman garage door openers flash the led next to the learn button to indicate a component failure. Inspect sensor wires for a disconnected or cut wire s.

The light from the opener blinks 10 times to warn you about misaligned photo eyes. The garage door opener will not close and the light s will flash. Realign the safety reversing sensors so that the led on the receiving sensor glows steadily. The garage door opener light will flash twice and the down button will begin to flash press and hold the down button till the garage door reaches the fully closed position.