1 the remote key could not lock or unlock all the door lock.
Suzuki door handle access switch not unlocking door.
My car has an automatic transmission.
On the forenza it has two wire connections attached to the switch one for routing power to it and one for the power.
10 12 crosstour 07 12 cr v 09 12 pilot with non power tailgate.
My car has 67000 miles.
Purchased on aug 30 2020.
Within 5 seconds of driver s door locking unlocking press remote control lock button fig.
A maximum of 2 remote controls can be programmed.
Front driver and passenger side interior door handle black.
You can lock and unlock all the doors including the tailgate of sx4 simultaneously by.
The rear gate not unlocking is due to the right front door remaining locked this is from a honda bulletin.
Posted on feb 06 2010.
My driver side door just stopped locking and unlocking when using the remote.
Your problem is with the right front door lock actuator failing the door latch assembly will probably have to be replaced.
Could not open any of the 4.
Just insert the screwdriver into the small hole and press the button on the inside of the handle with it to unlock the door.
Power door locking system.
When this issue occurs it s.
The remote will open and lock the other doors.
1 1 or unlock button 2.
Front or rear driver side interior door handle gray.
Confirm programming has been successful by locking and unlocking vehicle.
I have a 2007 suzuki reno basically same as forenza mechanically which had same door lock problem.
You do not need to pull and hold the door handle as you close the door.
Repeat step 4 three more times.
Repeat step 1 two more times.
Remove the key from the ignition switch and then insert it again.
If nothing seems to be wrong it is a good time to do electrical testing while you have access.
3 both the driver side s and front passenger side s power locking switch at the doors next to the power window switch.
There is a master door lock switch box connected to the front driver side door latch inside the door panel.
Insert the card between the lock and door frame then bend the card back to force the lock open.
Push the power door locking switch of the driver s door to the lock position and then push it to the unlock position.
Again check the unlock button for a poor wiring connection a dirty switch or any other sort of obvious damage.
Chances are the switch is simply not allowing enough voltage through to actually unlock the doors.
Suzuki interior door handle customer reviews.
Turning the key in a front door lock or pushing the power door locking switch located on the driver s side or the front passenger s side door panel.
For an interior door that has a small hole in the handle you can use a small screwdriver to unlock it.
The central power locking system of my 2007 suzuki sx4 seem to be malfunction.
Hi all need help.