The reset process appears convoluted but when followed closely it will reconnect the remote control with the motor control unit.
Sunsetter awning led lights not working.
If there is power present continue to the next step.
The set is cream colored to match your awning s hardware perfectly.
Unplug the power cord from the wall.
If not replace the cr2430 battery.
How to use the multi channel remote transmitter see figures 13 14.
The awning s motor or remote control is usually to blame when the unit stops working as you expect.
Flip it off and back on and then recheck the test panel.
There s a dedicated circuit breaker for the power converter.
Dimming the led strip off when the led light strip is fully on press and hold for more than second the down button on the remote transmitter.
If the red light does not come on at all or blinks for less than 5 seconds you will need to replace the battery see care and maintenance section on page 15.
T z z á z u o u µ o o ç v z o µ o z á v v p o v p x.
Sunsetter recommends channel 1 be used to operate your awning and channel 2 be used to operate your led light system unless you did not purchase a motorized awning then use channel 1 to operate your led light system.
Sunsetter recommends channel 1 be used to operate your awning and channel 2 be used to operate your led light system unless you did not purchase a motorized awning then use channel 1 to operate your led light system.
If the remote control stops working with the awning it needs to be reset.
If it does continue to the next step.
Press the neutral middle button on the transmitter.
Press and hold my for 8 seconds the light should blink the entire time.
Test to see if this restored operation if not continue to the next step.
Control box the first time the led light system is plugged in.
As you continue to hold the down button the led lights will dim down to fully off.
When a desired dimming level has been achieved release the down button.
Plug in the power cord and close the awning the rest of the way.
Be sure to order dimming led lights for your sunsetter awning.
If still not working you ll need to locate the power converter and make sure it s plugged into it s outlet.
Check power at the quick connect outlet or power source.
On many rigs it s located behind the rear wall of the pass through basement storage.
Unplug the motor and plug it back in.
You should always troubleshoot your awning before calling the manufacturer to see if you can solve the problem yourself.
You get a set of lights for each arm plus a waterproof transformer box that converts 110 volt to 12 volt to save energy.
Verify that the red light on the remote transmitter comes on when you press and hold the button.
Not available for the 1000xt model awning.
How to use the multi channel remote transmitter see figures 13 14.